The ME9601 Vibration Monitor has been designed to provide high integrity, cost effective protection for rotating machinery of all types including turbines, motors, fans and compressors etc.

It is ideally suited to applications where constant surveillance is required to protect machinery against sudden deterioration in condition and avoid costly breakdowns.

The monitor uses only the highest quality components and has been extensively type tested to ensure monitoring and prevent spurious alarms.

The monitor is housed in an IP66 wall mounted enclosure. The level of the channel is brought up on the internal display in engineering units, by depressing the ‘level’ button after initial system power-up. Alarm levels are displayed by pressing and holding the A1 or A2 buttons.

The monitor has its own PSU for increased system integrity, an internal BNC presenting the transducer buffered raw signal and a claibration check facility.

Three off volt free change over relays are provided, A1 and A2 level alarms, and A3 transducer/PSU integrtiy.

The status of A1 and A2 are indicated on the display panel by red LED’s illuminating when the alarms are initiated. The A3 alarm is annunciated by a normally lit green LED in the display panel, the transducer/PSU integrity alarm is able to inhibit A1 and A2 relays when in the Alarm State. A time delay of up to 5 seconds can be applied to alarms and is strongly recommended when the unit is used for trip purposes.

The monitoring mode, (A,V or D and peak or RMS) scaling and filters can be field set by the positioning of on board switches.

One current and one voltage output are available for recording/analysis purposes at the terminal blocks on the display panel.

Other parameters can be measured with monitors from the same series:-

ME9601 - Vibration Monitor
ME9602 - Rolling Element Monitor
ME9603 - Thrust/Axial Position Monitor
ME9608 - Rotational Speed Monitor
ME9609 - LVDT Displacement Monitor